Print speed exceeds the capacity of the media. Incorrect media sensitivity setting. Uneven print contrast density. Lower print speed or use media rated for the print speed being used. Clean the paper path.
|Date Added:||8 September 2017|
|File Size:||70.83 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Print head, platen roller or label path are dirty.
Lower print speed or use media rated for the print speed being used. The self-strip roller is dirty.
Use a higher quality label and ribbon stock. Incorrect darkness control setting Incorrect media sensitivity setting Poor quality label or ribbon stock Dirty print head.
Incorrect label rest point setting. Set the printer to thermal transfer or direct thermal label stock.
Intermec – Problems, Causes and Solutions
Printer is out of media. The media is loaded incorrectly.
Change the sensitivity setting to match the media type. The head lift lever should be straight up and down. Change sensitivity setting to match the media being used. Remove media from under the label sensor. Adjust the knob to achieve the best print quality.
Intermec EasyCoder PM4i Print head – Big Sales, Big Inventory and Same Day Shipping!
Incorrect label stock setting. User a higher quality label and ribbon stock. The AC power cable is damaged or disconnected. Properly position the label mark sensor. The label stock is loaded incorrectly. The print head is up. Iintermec port is incorrectly configured.
Clean the print head Clean the media path Use higher quality label and ribbon stock. The print head has overheated. Make sure the print head is down.
You have incorrectly set the image bands or print speed. Printer has aborted and reset the print speed and image bands. Check that the label and ribbon stock are adjusted properly.
Adjust the darkness control. Dirty print head Intremec media path or rollers Poor quality label or ribbon stock. If the sensitivity setting is correct, try changing the print darkness.
Printer breaker circuit tripped. Clean the paper path. Printing will resume when it has cooled. Be sure that the ribbon is installed with the shiny side facing the print head. Leave printer idle to cool.